Good day everyone,
I'm trying to design an Airlift manifold. I've seen some amazing work on this forum and I'd like to see if I can add anything myself.
Not exactly sure how it will be made but I may try 3D printing for some smaller versions.
Below are a few topics relating to the design.
I would appreciate your input for some design considerations so if you have anything to say about these topics your comments it would be great to hear:
Diameter of airlifts that would be useful?
Target flow rates?
Size of nozzle for the air line to attach to on the manifold?
I will probably go with 1mm radial holes for the air flow, possibly combined with axial flow above the radial holes. Depending on what the designer thinks I may suggest some air being injected to the centre of the pipe via a smaller pipe. If i go for 3d printing this should be possible. If anyone has any thoughts on the method of delivering the air would be good.
All the best
In depth subjects relating to Airlift.
1 post • Page 1 of 1